use this to cut the wood in a perfect 90 degrees angle

Use it for almost any wood cutting

Use for cutting smaller pieces

It is the perfect tool for making the finishing of the

3:18

holes in the keel or deck.

used for the metal wires and also

3:53

for cutting the ropes.

It is the glue you use for the surfaces you need to take pressure next, or where you need to have strength,

5:33

like the strips at the keel.

Use for glue almost everything

Very useful for opening small holes for various objects

This drill and tips are good for small holes ,

0:08

and in places that if you use a power drill you will damage the model.

0:12

It's better to use hand drill when ever you can, it is more secure.

The most useful tool,you need it to open holes ,form masts etc

they are harder than the normal tips

5:11

and they make a better "rounder" hole.

Without it you cannot build a wooden model

Best to use the 600 degrees type.

0:30

You can see here the sanded deck after the use of the 600 degrees paper.

0:38

The medium type, it is good for everything.

0:41

Also it is good to use it in the wood strips before you cut them into size.

Very useful for the planking

the most useful tool for the making of the hull.

used especially for the cutting of the masts.

3:38

Also good for cutting metal.

You must have one to be able to bend the wood strips.

4:47

It must have a round tip and it must be approximately 40watts.

You use this one to moisture the wood

For closing up all the gaps

Their only job is to keep a strip into place until it's glued.

used only in some cases that you need

1:41

to keep a wood in a certain place

use only pencils to mark anything on the wood strips.

It's very easy to erase, just sand it down.

use this for keeping the soldering iron into place so you can bent the wood strips.

It is also good for making wood marks.  You can make the marks without cutting the wood.

they are the perfect tools for bending metal objects or wires.

You have a use for almost everything

It is very useful when you need to hammer down a nail

4:11

and the hammer is to big to do it.

To hammer nails

you will use it at the end to place the sails in place.

The needle is needed for the sails ,but the needle threader is needed for passing ropes through many pieces.

Good for metallic pieces

you will need these when you sand down the keel. The heat will rise up quickly

you will need this to measure everything

Very useful for cleaning surfaces

4:03

from the saw dust.

To paint surfaces

For painting

You need this to apply it to the wood surfaces before applying anything else

6:44

like varnish or color.

The final touch

you will need it to clean the model before applying wood sealer or varnish.

Use for almost every metallic piece